Hot Feed Rubber Machine Screw and Barrel manufacturers take you to understand how to control the temperature of the rubber extruder

Hot Feed Rubber Machine Screw and Barrel manufacturers believe that when operating a rubber extruder, in order to produce rubber products normally, it is necessary to effectively control the temperature of the equipment. The accuracy of temperature control directly affects the quality of rubber products. So how to control the temperature?

Before the production of rubber products, the rubber extruder needs to be preheated to a specific temperature before the equipment can be turned on normally and the rubber raw material can be added to the feeding system.
How is the temperature of the rubber extruder controlled? The answer is water. Hot Feed Rubber Machine Screw and Barrel manufacturers tell you that generally manufacturers will use a water temperature-controlled mold temperature machine to increase the temperature of the water, and then use pressure to pass the conductor through the equipment circulating water to achieve temperature regulation. When using a rubber extruder, its temperature control is divided into several sections, each mold temperature machine controls a temperature control section, and when the temperature is constant, the temperature of the water is transferred to the barrel screw, so that the equipment can achieve an increase in temperature.
Hot Feed Rubber Machine Screw and Barrel manufacturers tell you that because the barrel and screw work continuously with each other during the production process, the temperature of the equipment will also increase under the operation of the barrel and screw.
However, too high temperature will be detrimental to the processing of rubber products. Therefore, it is necessary to control the temperature within a reasonable range to avoid continuous high temperature affecting processing. Therefore, when the temperature of the equipment is too high, cooling is required, and cooling is also required. Cooling by cooling water, which requires the use of a chiller.
Hot Feed Rubber Machine Screw and Barrel manufacturers tell you that the rubber extruder should effectively control the temperature of the equipment during use. Too low or high temperature will affect the production results. I hope you have a general understanding of the temperature control of the device after reading the above introduction.